The Alchemist’s Guide to Coatings: Transmuting Challenges Into Opportunities With Advanced Testing Kits


High Solids Coating

Last updated: August 3, 2018

What Does High Solids Coating Mean?

A high solids coating is a single- or two-component coating formulated to have higher concentrations (at least 65%) of solid components (binders, pigments and additives) than a conventional coating but still maintain satisfactory coating or application properties in spite of the lower percentage of volatile organic compounds (VOCs). A high solids coating can be solvent- or water-based.

High solids coatings are generally considered more environmentally friendly than conventional coatings because less solvent is emitted as it dries or cures.

A high solids coating may also be known as a high solids formulation.


Corrosionpedia Explains High Solids Coating

High solids coatings became widely used in the aerospace industry and other industries as a way to comply with the Environmental Protection Agency’s (EPA’s) emissions regulations. To address deteriorating air quality, the EPA enforces a law that limits the quantity of Volatile Organic Compounds (VOCs) or thinners/solvents emitted into the atmosphere.

Solvent-based coatings are generally ranked as a major source of harmful VOCs. While there is no requirement on the amount of solids in coating materials, higher solids content generally implies that there is lower solvent content, thus reducing VOC emissions. Paint manufacturers developed and produced low-VOC coatings in reaction to stricter environmental regulations.

High solids coatings are durable, cost-effective and less harmful to human health and the environment, but they are more expensive and require spray equipment and more skill to apply. Other disadvantages compared to conventional coatings are:

  • Higher viscosity, which causes difficulty when spraying.
  • Shorter shelf life.
  • Sensitivity to inadequate substrate cleaning.
  • Narrower "time-temperature-cure" application window.
  • More difficult to repair.

So, why don’t they just use water-based coatings?

Water-based coatings that contain very little solvents seem to be the logical solution to the problem of exceeding the VOC emission limits. However, while water is recognized as the universal solvent, it is also a key component that favors the corrosion process. This is not a problem with solvent-based coatings.



High Solids Formulation

Share This Term

  • Facebook
  • LinkedIn
  • Twitter

Related Reading

Trending Articles

Go back to top