Understanding Corrosion in Water Pipelines: A Guide for Pipeline Designers


Detonation Gun (D-Gun)

Last updated: November 3, 2017

What Does Detonation Gun (D-Gun) Mean?

A detonation gun (D-gun) is device that can deposit a variety of materials and ceramic coating at supersonic speeds onto a workpiece by controlled detonation of oxygen and acetylene. It is used in the thermal spraying process for providing hard, wear-resistant and dense-microstructured coatings.

The D-gun coating process, invented in 1948, is still the leading thermal spray process when extraordinary wear and mechanical properties are needed. This process generates outstanding bond strength and density. Typical applications include:

  • Fan blade midspans in aviation engines
  • Turbine blade z-notches
  • Knife-edge seals in power generation
  • Steel-sheet roller guides
  • Extruders

Corrosionpedia Explains Detonation Gun (D-Gun)

The detonation gun is considered the first high-velocity thermal spray process. It gives an extremely good adhesive strength, low porosity and coating surface with compressive residual stresses. The detonation gun consists of a long water-cooled barrel with inlet valves for gases and powder. Oxygen and fuel (acetylene most common) is fed into the barrel along with a charge of powder. A spark is used to ignite the gas mixture, and the resulting detonation heats and accelerates the powder to supersonic velocity through the barrel. A pulse of nitrogen is used to purge the barrel after each detonation. This process is repeated many times a second. The high kinetic energy of the hot powder particles on impact with the substrate results in a buildup of a very dense and strong coating.

D-gun coating provides extended life to parts. It gives dependable wear and corrosion-resistant surface on machine parts under difficult service conditions. For example, detonation-gun spray coating of 437H boiler steel can be used to enhance its high-temperature corrosion resistance.

The resultant deposits porosity is low (below 1 %) and its oxygen content is between 0.1-0.5%. The deposition efficiency is about 90%, for powder flow rates of 1 to 2 kg/hour. The sprayed materials are mainly powders of metals, alloys and cermets; some oxides can be sprayed but with particle sizes in the 20µm range or below. Substrate and coating must be cooled during spraying. The main applications are coatings against abrasion and adhesion (friction) under low load as well as coatings against corrosion.


Share This Term

  • Facebook
  • LinkedIn
  • Twitter

Related Reading

Trending Articles

Go back to top